Tips for using manual tools staples

A stapler is a commonly used office supply. I believe everyone has used it. The stapler is generally used to bind paper and documents, but many people do not install manual tools staples. Let's take a look at manual printing. What are the tricks of the stapler?

Here is the content list:

• Select the needle orientation for Manual Tools Staples.

• Loading of Manual Tools Staples.

Select the needle orientation for manual tools staples.

There will be a small piece of iron on the base of the stapler, and there are two sets of grooves of different sizes, which are found in almost all manual tools staples. This small piece of iron can be rotated. The stapler has a switch on the bottom. You only need to press and hold the iron on the switch to turn it. We tried to turn the set with the larger grooves. Usually, when we use the stapler to bind the paper, the staples of the manual tools staples are always facing inward, and we use this set of large grooves for binding. If so, the pins of the Manual Tools Staples are reversed outward. These two groups of different grooves have different functions, and the reverse of the staples of manual tools staples is also different. It depends on your own needs. If the staples face outwards, it is easier to remove the staples.

Loading of manual tools staples.

To load the manual tools staples of the stapler, the stapler needs to be separated from the top and bottom to both sides, pay attention to the state that it needs to be separated to 180 degrees, so as not to hurt the fingers from the rebound of the stapler. Place the opening of the stapler down in the groove of the stapler, then close the separate stapler to its original position and you are ready to use. After installing the stapler, you need to press down once to fit the upper arm of the stapler into the base. When using the stapler, you need to press down firmly, otherwise, the manual tools staples will not output smoothly. 

Note that when installing nails to the stapler, the position cannot be wrong, and the opening of the nails needs to be facing down so that the nails can be ejected after pressing. It is also necessary to install manual tools staples of suitable size, so as not to be too large or too small, the nails will not match the stapler and cannot be used. The installed stapler needs to be firmly pressed down once to make the upper arm of the stapler fit the base completely for better use. When using the stapler, you need to place the stapler correctly on the edge of the paper and press it down hard.

If you are interested in the manual tools staples, you can contact us, our website is https://www.jkstaple.com/, you are welcome, and look forward to cooperating with you.