How to Install Industrial Staples?

The binding is usually made of iron before it is plated with a layer of nickel or a nickel-zinc alloy to prevent rust. More high-end products may also use steel as the raw material. So, how to install Industrial Staples?

Here is the content list:

• Installation before installing Industrial Staples.

• The process of installing Industrial Staples.

Installation before installing Industrial Staples.

First, install the handle, put the handle prepared in the box into the position of the square axis on the right side of the binding machine, and tighten it with screws. Before preparing to bind Industrial Staples, read the manual carefully and consider the amount of binding paper. Then it is to adjust the scale with the adjusting screw (installed behind the binding machine) to adjust the paper margin when adjusting the paper margin. When adjusting, the diameter of the pull ring is large, the margin of the paper is increased, the diameter of the pull ring is small, and the margin of the paper is decreased. You can adjust the appropriate paper margins as needed. After placing the paper, we need to punch holes in the paper, arrange the paper neatly, close to the positioning block, and then feed the paper into the machine in parallel until it is in place, press the paper with the left hand, hold the handle with the right hand, and press down to the blade. Penetrate the paper and lift the handle again.

The process of installing Industrial Staples.

Before stapling, we also need to put industrial staples on the machine. First, loosen the fixing screw on the stitcher, remove the stitcher, hang the hook at the end of the Industrial Staples into the fixing hole of the staple, keep it vertical, and then put the pin catcher into the original position of the binding rod, and finally tighten the fixing screw on the pin catcher. Go to the last step, binding, first turn the presser foot handwheel clockwise to raise the presser foot, put the binding material under the presser foot, put the paper in, release the presser foot handwheel to automatically press, and then put the presser foot turn the handwheel counterclockwise about 180° to lock it, and then turn the staple handle counterclockwise, and the staple goes through the material. After the lead arm automatically hangs the thread in the thread groove of the staple hook, you can lift the handle upward. When the staple is withdrawn, the binding thread will be locked, and then release the presser foot handwheel clockwise. The binding of Industrial Staples can be completed, and the above procedure can be repeated.

Our official website is https://www.jkstaple.com/. If you are working with Industrial Staples or would like to learn more about our company, you can communicate with us on the website. Our cost-effective products are highly praised by everyone. Our mission is to provide our clients with the best possible service and focus on building long-term partnerships that we believe will lead us to a win-win situation. We are committed to putting our customers first, and we will be loyal, sincere, and responsible when we are involved in the global Industrial Staples business.